House Opatija (Croatia) Price: $ 4,280,000 USD

• Euro (€ EUR)
• American Dollar ($ USD)
• British Pound (£ GBP)

Surface 758 m²

Beautiful new exclusive villa of 758 m2, located in the center of Opatija, built on a plot of 703 m2 near the sea, promenade and beach !! The villa has a beautiful sun terrace of 60 m2 built to serve as a pergola for parking located below the villa. This building consists of a garage-basement floor, ground floor, first and second floor. On the plot there are four parking spaces, two to three parking spaces were obtained in the basement where there is also an engine room for heating, washing room, large tavern with grill fireplace, bathroom, sauna and gym. The structure is divided into three completely separate and one from the other independent housing units. On the ground floor there are two apartments with separate entrances. The first apartment consists of a living room, kitchen, dining room, bathroom and two bedrooms. The second apartment is one bedroom with a large living room, kitchen dining room and bathroom. The third, central apartment is three-storey. It is connected to the basement. On the first floor there is a large living room, kitchen, dining room, two bedrooms, bathroom, guest toilet and hallway. On the second floor there are two bedrooms, bathroom, hallway and large jacuzzi whirlpool. Each room has its own terrace and a beautiful sea view. This villa is built of top quality materials. The potential buyer receives with all the necessary documentation and approximately a thousand photos about the course of construction from which it is visible which materials are installed in the villa. The complete basement floor, as well as all other concrete works, is made of water-tight concrete of the strongest brand, insulated with additional hydro and thermal insulation and walled with another wall of concrete cube. The supply of fresh air and natural light is enabled by aco light shafts. The walls are made of the highest quality porotherm brick, 30cm thick. The thermal façade is silicone, the thickness of the thermal insulation is 10 cm. Some details of the façade are made of alucobond sheet. We can also emphasize that the façade part of the building is illuminated by outdoor lighting in a very effective LED technique. The complete joinery is aluminum, the most famous German manufacturer SCHÜCO, glazed with tempered stop-salt grey glasses thickness of 2x6 mm and 2x8 mm and protected by aluminum electric shutters controlled by ROLTEC. The installation of carpentry is done with RAL installation so that the villa is energy passive. Each opening is covered by an anti-theft system as well as video surveillance. The interior doors are of modern design (brushed oak) with magnetic closure. The bathrooms are equipped with equipment from renowned manufacturers, Villeroy & Boch, Geberit, Viega, Paffoni. Heating and cooling of the facility was achieved using heat pumps (altermi) of the top brand DAIKIN which is definitely number one for heating and cooling. All rooms (even basement-garage) in this building have underfloor and ceiling heating, as well as cooling. It is necessary to note once again that each apartment has its own separate heating, water and electricity. Each room has digital thermostats that allow different heating and cooling of rooms as well as their parts. Switches, sockets and thermostats throughout the house are brand VIMAR with stainless steel design masks from the same manufacturer. The floors are finished using dry screed technique and lined with gres linings (ground and pressed granite). The ceilings are knauf lowered and illuminated by LED lighting. The walls are plastered with finished fine plaster and additionally glittered. The garden is decorated and with a beautiful sea view. The grassy part is enriched with tall palm trees and ornamental vegetation. On the garden there is a swimming pool with a sun terrace that is completely fenced with a metal-stainless steel fence. Top unique nekre